IC-LM723 10 volt Regulator menggunakan circuit and explanation

This is a circuit of an IC LM723 voltage regulator. This IC has a voltage reference source, an error amplifier, a series pass transistor, and a current limiting tran sistor all contained in one small package. The device can be connected to operate as a positive or negative voltage regulator with an output voltage ranging from 2 V to 37 V, and output current levels upto 150 m A. The maximum supply voltage is 40 V, and the line and load regulations are each specified as 0.01%.

Skema rangkaian regulator menggunakan iC LM723

IC regulator LM 723 connected to operate as a positive voltage regulator. The output voltage can be set to any value between approximately 7 V (reference voltage) and 37 V by appropriate selection of resistors R1 and R2. A potentiometer may be included between R1 and R2, of course, to make the voltage adjustable. An external transistor may be Darlington connected to Q1 (as shown in earlier post) to handle large load current. The broken lines in the figure shows connections for simple (non-foldback) current limiting. (Foldback current limiting can also be used with IC LM723). A regulator output voltage less than the 7 V reference level can be obtained by using a voltage divider across the reference source [terminals 6 and 7 in earlier figure]. The potentially divided reference voltage is then connected to terminal 5.

It is important to note that the supply voltage, at the lowest point on the ripple waveform, should be at least 3 V greater than the output of the regulator and greater than VREF; otherwise a high-amplitude output ripple may occur.

Paramaters IC Regulator lm723

Output Current 150 mA
Output Voltage Undefined Volt
Input Min Voltage 9.5 Volt
Input Max Voltage 40 Volt
Adjustable Output Yes
On/Off Pin No
Error Flag No
Temperature Min -55 deg C
Temperature Max 150 deg C.